AMG Solution - SheetTEC, indirect corona surface treatment for sheets and plates

The TANTEC SheetTEC Indirect Corona Surface Treatment Station is used to increase the surface tension by indirect Corona treatment of sheets or plates.

The corona surface treatment will improve the surface tension of your parts and supports to allow better adhesion of coatings, glues, inks or paints. This process will allow you to increase the quality of your production with more resistant assemblies, better ink retention on your plastic parts, etc.

The SheetTEC indirect corona treatment station is easy to set up on an existing production line, or standalone for greater flexibility of use. The SheetTEC indirect Corona surface treatment station is based on the principle of electric discharge blown onto a surface.

The SheetTEC indirect Corona surface treatment will improve the surface tension of your sheets or plates to optimize the adhesion of glues, inks and other coatings.

The SheetTEC corona surface treatment station treats sheets or plates with a thickness of 50 mm , it can also treat surface dimensions between 50 and 2000 mm, front and/or back, up to 10 meters per minute. The SheetTEC corona surface treatment station is very flexible allowing the treatment of small, medium and large surfaces.

Discover in a few points the other strong points of the SheetTEC indirect corona surface treatment station:

• Easy to install and use,
• For Front and/or Back treatment of your sheets and plates,
• Low operating cost,
• Watt density control,
• For stand-alone or online use,
• Full process control.

Discover all our other direct or indirect corona surface treatment solutions on our website or by contacting us by email .